ABS: 4E-47
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Remove the meter panel. Refer to “Meter Panel
Removal and Installation” in Section 9D in related
manual.
3) Check the ABS control unit coupler and front wheel
speed sensor coupler for loose or poor contacts. If OK,
then disconnect the ABS control unit coupler. Refer to
“ABS Control Unit Coupler Disconnect and Connect
(AN400A/ZAK9)” (Page 4E-71).
4) Measure the resistance between “12” (B/R) and ground
at the ABS control unit coupler.
Special tool
(A): 09900–25008 (Multi circuit tester set)
(B): 09900–25009 (Needle-point probe set)
Tester knob indication
Resistance (Ω)
Normal value (“12” – Ground)
∞ Ω (Infinity)
Is the resistance between “12” and ground OK?
Go to Step 3. Go to Step 2.
I905H1450041-01
12
ABS control unit coupler
(Harness side)
18
10 13
234
16
89
24
25
21
(A)
(B)
I905H1450075-01
To Next Page
Loading...
