106
Engine speed will not increase:
• Propeller is damaged.
• Propeller is not clean.
• Propeller is not properly selected.
• Outboard motor is not correctly installed.
• Trim angle is not properly adjusted.
• Spark plug is fouled or incorrectly selected.
• Fuel hose is kinked or pinched.
• Fuel filter is clogged.
• Fuel is deteriorated.
• Fuel pump is failed.
• Ignition system is failed.
• Electronic throttle system is failed.
• Heavy cargo is on the boat.
• Water has entered into the boat.
• Bottom of boat is not clean or damaged.
Engine vibrates excessively:
• Propeller is damaged.
• Engine mounting bolts or clamp screws are
loose.
The Keyless Start System does not turn
ON even when the main switch is oper-
ated. The error sound (five short buzzer
beeps) is NOT
heard:
(If equipped with Keyless Start System)
• Emergency stop switch lock plate is not in
position.
• The main switch has been operated continu-
ously while the communication with the key-
fob is disabled.
• Battery terminal connection is corroded or
lost.
• Battery power is lost.
• Keyless control unit failure.
• Electric wiring connection is loose.
• Main panel failure.
The Keyless Start System does not turn
ON even when the main switch is oper-
ated. The error sound (five short buzzer
beeps) IS
heard:
(If equipped with Keyless Start System)
• Key-fob is outside the operating range.
• Key-fob battery is dead.
• Key-fob is in OFF mode.
• The key-fob is not authenticated.
• Communication failure due to strong radio
wave or noise.
• Electric wiring connection failure between the
keyless control unit and outboard motor.
• Authentication error between the keyless
control unit and outboard motor.
• Abnormality exists in the electronic control
system of the engine.
The Keyless Start System does not turn
OFF even when the main switch is oper-
ated:
• Electric wiring connection is loose.
• Main panel failure.
FUSE
1. If equipped with Keyless Start System:
Turn the Keyless Start System OFF.
If not equipped with Keyless Start System:
Turn the main switch to the “off” position.
2. Remove the motor cover.
3. Remove the fuse box cover and pull off the
fuse.
Fuse box cover
To Next Page
Loading...
