72
STOPPING THE ENGINE
NOTE:
When it is necessary to stop the engine in an
emergency, pull the emergency stop switch lock
plate by pulling the emergency stop switch
cord.
If equipped with Keyless Start System:
To stop the engine:
1. Shift into “NEUTRAL”.
2. After operating at full throttle, cool off the
engine a few minutes by allowing it to idle or
troll at low speed.
3. Push the “START & STOP” switch to stop the
engine.
4. Turn the Keyless Start System to OFF
(locked) status by one of the following meth-
ods.
• Make sure that the key-fob is within the
communication range of the keyless con-
trol unit.
Turn the main switch to the “ ” position
and then release it. The main switch auto-
matically returns to the “ ” position.
The buzzer sounds once to notify that the
Keyless Start System has been turned to
OFF (locked) state.
• While the key-fob is within the communi-
cation range of the keyless control unit,
press the lock button 1 on the key-fob.
The buzzer sounds once to notify that the
Keyless Start System has been turned
OFF (locked).
NOTICE
If the Keyless Start System is in ON state
while the engine is not running, the battery
will be discharged.
Always turn the Keyless Start System to OFF
state when the engine is not running.
To Next Page
Loading...
