Suzuki DF350A - Tool Kit; Spark Plug

84
TOOL KIT
A tool kit is provided with your outboard motor.
Keep the kit on board your boat and make sure
that all of the items provided remain in the kit.
The tool kit contains the following items:
1 Tool bag
2 8 mm Box wrench
3 8 × 10 mm Box wrench
4 16 mm Box wrench
5 Combination screw driver
6 Screwdriver handle
7 Pliers
8 Hexagon wrench 4 mm
9 Hexagon wrench 8 mm
0 Engine oil drain plug gasket (spare)
• Frequent shift operation
Failure to perform maintenance more fre-
quently could result in damage.
Consult your authorized Suzuki marine
dealer regarding appropriate mainte-
nance intervals for your usage condi-
tions. When replacing parts on your
outboard motor, Suzuki strongly recom-
mends that you use genuine Suzuki parts
or their equivalent.
SPARK PLUG
Remove the spark plugs as follows:
1. Remove the motor cover.
2. Remove the ignition coil bracket bolts and
ignition coil brackets 1.
3. Remove the bolt securing the ignition coil.
4. Pull out the ignition coil.
NOTE:
Turn the ignition coil A clockwise as shown in
the figure to remove.
The installation is a reverse procedure of the
removal.
NOTICE
When servicing the iridium/platinum
spark plugs, do not touch the center elec-
trode, as it is easy to damage.
Do not touch the center electrode of an
iridium spark plug. Avoid cleaning it or
adjusting its electrode gap.