25
Propeller removal
To remove the propeller on your outboard
motor, use the following procedure.
1. Shift to “NEUTRAL” position.
2. Remove the cotter pin 1 from the rear pro-
peller nut and remove the rear propeller nut
2.
3. Remove the washer 3, spacer 4, rear pro-
peller 5 and rear propeller stopper 6 from
the propeller shaft.
4. Straighten the locking edges on the front
propeller nut stopper 7 from the front pro-
peller nut and remove the front propeller nut
8.
NOTE:
• Front propeller nut is left hand thread.
• For removing or installing the front propeller
nut, the “Propeller nut remover & installer”
(Suzuki genuine part), is required. Consult
your authorized Suzuki marine dealer for
Suzuki genuine parts.
5. Remove the front propeller nut spacer 9,
front propeller 0 and front propeller stopper
A from the propeller shaft.
To Next Page
Loading...
