65
3. Push the start & stop switch to start the
engine.
NOTE:
By pressing the Start & Stop switch once, the
starter motor turns for 3 seconds continuously
until the engine starts.
NOTE:
The continuous operating time of the starter
motor is set at five seconds.
When this time is exceeded, the starter motor
will automatically stop.
If the motor stops, wait about ten seconds for
the motor to cool down and try again.
NOTICE
If you hold in the START & STOP switch
to start the engine, the starter system can
be damaged.
Push the START & STOP switch and
release it to start the engine. The engine
will crank continuously for 3 seconds or
until the engine starts.
NOTICE
If “Low Oil Pressure” is displayed on the
screen of the meter while operating the
outboard, the oil level may be low enough
to damage the engine.
Stop the engine and check the oil level.
4. Warm up the engine for about 5 minutes.
Cooling water check
As soon as the engine starts, water should
spray out of the pilot water hole 1, indicating
that the water pump and cooling system are
working properly. If you notice that water does
not spray out of the pilot water hole, stop the
engine as soon as possible and consult your
authorized Suzuki Marine Dealer.
NOTICE
Operating the engine at high RPM or
“wide open throttle” immediately after
starting the engine without allowing the
engine to warm up may cause engine fail-
ure.
Always allow the engine to warm up suffi-
ciently before operating it at high speeds.
To Next Page
Loading...
