69
To start the engine:
(5)Install the lock plate 3 on the emergency
stop switch.
(6)Make sure the motor is in “NEUTRAL”.
(7)Push the START & STOP switch to start the
engine.
To stop the engine:
1. Shift into “NEUTRAL”.
2. After operating at full throttle, cool off the
engine a few minutes by allowing it to idle or
troll at low speed.
3. Push the START & STOP switch to stop the
engine.
4. Turn the emergency key to the “ ” position
and then release it to the “ ” position to
turn the Keyless Start System to OFF state.
And then, pull out the emergency key from
the key cylinder.
NOTE:
The passcode authentication state is main-
tained for 15 seconds after turning the emer-
gency key to the “ ” position. In this state, the
engine can be started by turning the emer-
gency key to the left and pressing the START &
STOP switch. To restart the engine when the
15-second period has elapsed after turning the
emergency key to the “ ” position, repeat the
emergency key operation from the beginning.
To Next Page
Loading...
