ENGINE 3-11
• Remove the cylinder head bolts diagonally.
• Remove the cylinder head.
NOTE:
If the cylinder head does not come off, lightly tap on the finless
portion of it with a plastic hammer.
CYLINDER
• Remove the gasket
1.
• Remove the cam chain guide
2.
• Remove the cylinder by removing the nuts.
NOTE:
If the cylinder does not come off, lightly tap on the finless portion
of it with a plastic hammer.
PISTON
• Place a clean rag over the cylinder base to prevent the piston
pin circlip
3 from dropping into the crankcase. Then, remove
the piston pin circlip
3.
• Remove the piston pin.
NOTE:
Use the special tool if necessary.
! 09910-34510: Piston pin puller
• Remove the piston.
GENERATOR COVER
• Remove the generator cover.
To Next Page
Loading...
