3-48 ENGINE
• Tighten the crankcase bolts to the specified torque.
! Crankcase bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
* After the crankcase bolts have been tightened, make sure that
the crankshaft, countershaft and driveshaft rotate smoothly.
* If these shafts do not rotate smoothly, try to free it by tapping
with a plastic hammer.
• Install the gearshift cam stopper.
• Apply SUZUKI SUPER GREASE “A” to the O-ring of the
engine sprocket spacer and the oil seal lip. When installing
the engine sprocket spacer onto the driveshaft, face the
grooves
A toward inside.
" 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
#
CAM CHAIN/GENERATOR STATOR
• Install the cam chain.
• Remove any grease from the tapered portion of the generator
rotor and crankshaft.
• Install the generator rotor key
1.
Use a new O-ring.
To Next Page
Loading...
