Swann AMI INSPECTOR pH - Install Swansensor pH SI

12 A-96.250.761 / 161017
AMI INSPECTOR pH
Installation
3. Installation
3.1. Installation Checklist
Check
 Instrument’s specification must conform to your AC power
ratings. See External power adapter, p. 20.
 Check if the battery is fully charged.
Installation
 Connect sample inlet and outlet to the flow cell.
pH electrode
 Install the sensor (see Install Swansensor pH SI, p. 14).
 Connect sensor cables.
 Store the protective caps for later use.
Power-up
 Turn on the sample flow and wait until the flow cell is
completely filled.
 Switch on power.
Instrument
set-up
 Adjust sample flow.
 Program all parameters for sensor.
 Program all parameters for instrument operation (limits,
alarms).
Run-in period
 Let the instrument run continuously for 1 h.