Swann AMI INSPECTOR pH - Program List and Explanations

48 A-96.250.761 / 161017
AMI INSPECTOR pH
Program Overview
8.5. Installation (Main Menu 5)
Sensors Flow Flow measurement 5.1.1.1* * Menu numbers
5.1* 5.1.1*
Parameter Type of sensor 5.1.2.1*
5.1.2* Sensor Check 5.1.2.2*
Temperature Temp. Sensor 5.1.3.1*
5.1.3* Default Temp. 5.1.3.21*
Temp. Compensation Comp. 5.1.3.3.1*
5.1.3.3*
Standards Standard 1 @ 0 °C–50 °C 5.1.40.1.1–10*
5.1.40* 5.1.40.1*
Standard 2 @ 0 °C–50 °C 5.1.40.2.1–10*
5.1.40.2*
Signal Outputs Signal Output 1/2 Parameter 5.2.1.1 - 5.2.2.1*
5.2* 5.2.1* - 5.2.2* Current Loop 5.2.1.2 - 5.2.2.2*
Function 5.2.1.3 - 5.2.2.3*
Scaling Range Low 5.2.x.40.10/10*
5.2.x.40 Range High 5.2.x.40.20/20*
Relay Contacts Alarm Relay Alarm Alarm High 5.3.1.1.1*
5.3* 5.3.1* 5.3.1.1* Alarm Low 5.3.1.1.26
Hysteresis 5.3.1.1.36
Delay 5.3.1.1.46
Sample Temp. Alarm High 5.3.1.3.1*
5.3.1.3 Alarm Low 5.3.1.3.26*
Case Temp. high 5.3.1.5*
Case Temp. low 5.3.1.60*
Relay 1/2 Function 5.3.2.1–5.3.3.1*
5.3.2* - 5.3.3* Parameter 5.3.2.20–5.3.3.20*
Setpoint 5.3.2.300–5.3.3.301*
Hysteresis 5.3.2.400–5.3.3.401*
Delay 5.3.2.50–5.3.3.50*
Input Active 5.3.4.1*
5.3.4* Signal Outputs 5.3.4.2*
Output/Control 5.3.4.3*
Fault 5.3.4.4*
Delay 5.3.4.5* * Menu numbers