Swann AMI INSPECTOR pH - Maintenance (Main Menu 3); Operation (Main Menu 4)

AMI INSPECTOR pH
Program Overview
A-96.250.761 / 161017 47
8.3. Maintenance (Main Menu 3)
8.4. Operation (Main Menu 4)
Calibration Process pH Process pH 3.1.1.4* * Menu numbers
3.1* 3.1.1*
Standard pH Standard pH 3.1.2.5*
3.1.2*
Simulation Alarm Relay 3.2.1*
3.2* Relay 1 3.2.2*
Relay 2 3.2.3*
Signal Output 3 3.2.4*
Set Time (Date), (Time)
3.3*
Sensors Filter Time Const. 4.1.1*
4.1* Hold after Cal. 4.1.2*
Relay Contacts Alarm Relay Alarm Alarm High 4.2.1.1.1*
4.2* 4.2.1* 4.2.1.1* Alarm Low 4.2.1.1.26*
Hysteresis 4.2.1.1.36*
Delay 4.2.1.1.46*
Relay 1/2 Setpoint 4.2.x.100*
4.2.2* - 4.2.3* Hysteresis 4.2.x.200*
Delay 4.2.x.30*
Input Active 4.2.4.1*
4.2.4* Signal Outputs 4.2.4.2*
Output / Control 4.2.4.3*
Fault 4.2.4.4*
Delay 4.2.4.5*
Logger Log Interval 4.3.1*
4.3* Clear Logger 4.3.2* * Menu numbers