AMI INSPECTOR pH
Program List and Explanations
A-96.250.761 / 161017 51
2.3 Sample
If <Flow measurement> = None and <Temp. Sensor> = no
2.3.301 Sample ID: Shows the assigned sample identification. This
identification is defined by the user to identify the location of the
sample
Temperature: Shows the predefined comp. temperature in °C.
If <Flow measurement> = Q-Flow and <Temp. Sensor> = no
2.3.311 Sample ID: Same as 2.3.301
Temperature: Same as 2.3.301
Sample flow: Shows the actual sample flow in l/h and the
Raw value in Hz
2.4 I/O State
Shows actual status of all in- and outputs.
2.4.1
2.5 Interface
Protocol USB Stick.
Alarm Relay:
Active or inactive.
Relay 1 and 2:
Active or inactive.
Input:
Open or closed.
Signal Output 3:
Actual current in mA
To Next Page
Loading...
