EN-30
INSTRUCTIONS FOR USING THE
MOTORCYCLE
Note*: If you are not familiar with the motorcy-
cle operation, read paragraphs on “CONTROLS”
before riding this motorcycle.
PRELIMINARY CHECKS
Any time you ride your motorcycle, make a gen-
eral inspection first and proceed to check the
following:
-Check fuel level and engine oil level;
-Check the brake fluid level;
-Check the steering by turning the handlebar
both ways, fully home;
-Check the tyre pressure;
-Check the chain tension;
-Check and if necessary adjust the throttle con-
trol;
-Turn the ignition switch to position: check
the lighting of instrument display and, with
gearbox in neutral, make sure that the neutral
warning light comes on;
-Turn on the high-beam light and check that the
relative warning light comes on;
-Operate the turning indicators and check that
the warning light comes on;
-Check if the rear stop light is functioning;
-Check that, after starting, the " " “Engine
fault” and the” " “ABS fault”lights are not on.
INSTRUCTIONS FOR RUNNING-IN
The exclusivity of the design, with the high qual-
ity of the materials used and the accuracy of the
assembly, guarantee the highest comfort right
from the start.
However, when running for the first 1500 Km,
SCRUPULOUSLY follow the rules mentioned be-
low. Please note that FAILURE TO COMPLY WITH
THESE RULES MAY COMPROMISE THE LIFE AND
THE PERFORMANCE OF THE MOTORCYCLE:
-Warm up the engine by running at low rpm be-
fore using the motorcycle;
-Avoid quick starts and never rev up the engine
when in low gear;
-Ride at low speed until the engine is warmed
up;
-Apply both brakes several times to run-in the
pads and the discs;
-Do not maintain the same speed for a long time;
-Do not ride for a long time without stopping;
-NEVER ride downhill with GEARBOX IN
NEUTRAL, but shift into gear in order to use the
engine braking, thus preventing the fast wear of
the brake pads.
OPERATION PROBLEMS
The following list is used for troubleshooting and
to find the necessary remedies
The engine does not start
-The starting procedures are not correctly fol-
lowed: follow the instructions given on para-
graph “Starting the engine”.
-Dirty spark plug: clean;
-The spark plug does not spark: adjust the elec-
trodes gap;
-Faulty starter motor: repair or replace;
-Faulty start button: replace the switch;
-Side stand lowered.
To Next Page
Loading...
