35- EN
STARTING THE ENGINE
After getting on the motorcycle as described in
the relative paragraph, operate as follows to start
the engine:
-Place ignition key (1) to position (the buzz
that you hear when you turn the key to is
caused by the fuel pump which puts the feeding
system under pressure);
-Pull the clutch lever (2), lift the side stand, or shift
gear pedal (3) to neutral, Check that the button (4)
is in position and then press the start button (5).
When a cold engine has just been started, do not
increase revs, to ensure an adequate oil warmup
and circulation.
WARNING
Do not run the cold motor with a high number
of revs.
Note*: A safety switch is set on the clutch lever
support. This switch allows you to ONLY start the
engine with the gearbox idle, or with the gear en-
gaged and the clutch lever pulled.
With the stand lowered, the bike can only be
started with the gear in neutral.
To Next Page
Loading...
