20
6.2 Diagnostics
6.3 Methods
Methods Description
Clear All Runs Clear all runs from the memory
Close Chuck Close the pneumatic chuck
Get Programs Get the list of available programs
Get Results Get the last measurement results
Load Program Load a program using the program file name
Lock Tailstock Move down and lock the tailstock
Move Rotation To Position Move the Rotation axis to a specific position
Move Slide to Position Move the Slide axis to a specific position
Move Tailstock to Position Move the Tailstock axis to a specific position
Move Tilt to Position Move the Tilt axis to a specific position
Open Chuck Open the pneumatic chuck
Park Axis Move all axes to the parking/loading position
Remote Lock Block the 'automation mode'
Set Custom SPC <special>
Start Calibration Start the execution of the calibration
Start Program Start the execution of a measurement program
Stop Program Stop the execution of the current program
Unlock Tailstock Move up and unlock the tailstock
GetToolCorrections Get the proposition for each corrector in an XML format or text format
ResetCorrectionStatus Reset the 'Correction Status'
To Next Page
Loading...