Sylvac SCAN S25 - Nodes

21
6.4 Nodes
Node Description
Rotation Position of the rotation [°]
Slide Position of the slide [mm]
Tailstock Position of the tailstock [mm]
Tilt Position of the tilt [°]
ApplicationMode Application Mode (e.g. Composer, ReflexClick, Replay, Remote)
ApplicationVersion Version of SYLVAC-REFLEX Scan
Calibrated Calibration state
ChuckStatus The status of the pneumatic chuck ('Unknown', 'Closed', 'Open')
IsParked Is machine in parking position
MachineID Machine ID
MachineType Machine type (e.g. 'F60', 'F60T', 'F60L', 'F60LT', 'S145', 'S145L')
TailstockStatus The status of the tailstock ('Unknown', 'Locked', 'Unlocked')
ProgramName Program name
ProgramResult
Program result (e.g. 'None', 'NoClass', 'Passed', 'WarningRework',
'WarningReject', 'Rework', 'Failed', 'Invalid')
ProgramState
Program state (e.g. 'Idle', 'Loading', 'Saving', 'Printing', 'Moving',
'LockingTailstock', 'UnlockingTailstock', 'Calibrating', 'Repositioning',
'Scanning', 'ResultsReady')
TraceField1 Program Trace Field 1
TraceField2 Program Trace Field 2
RegOutNum1 Register Output Numerical 1
RegOutNum2 Register Output Numerical 2
RegOutNum3 Register Output Numerical 3
RegOutNum4 Register Output Numerical 4
RegOutNum5 Register Output Numerical 5
CorrectionDate Timestamp of last tool corrector proposition
CorrectionMachineName Machine's name of last tool corrector proposition
CorrectionStatus
Correction Status (e.g. 'WaitingProposition', 'PropositionReady',
'ImpossibleToCorrect')