Deployment Solution 386
Command-Line Switches
TcpPort This is the IP port number of the Deployment Server
listening for requests (Optional). Specifying this
parameter will switch the ADL Agent to use TCP to
connect to the Deployment Server.
Example:
TcpPort=402.
WakeOnLANProxy Specifies whether to proxy Wake on LAN packets.
Example: WakeOnLANProxy=True.
MCastProxy Specifies whether this agent will advertise the
presence of the Deployment server. Specifies whether
to proxy Multicast packets.
Example: MCastProxy=True.
UseFQDN Specifies whether the ADLAgent should attempt to
reverse the IP address to return a proper ‘fully
qualified domain name’ to the Altiris Deployment
Server. If the network is set up to properly resolve
PTR record requests this option will return the fully
qualified name of the agent, such as
myhost.mydomain.com. However, if the network does
not resolve PTR records, this option may delay
adlagent connection by as much as a minute or two.
Example: UseFQDN=True.
UseHardTimeout Specifies whether to use the hard time out or not.
Example: UseHardTimeout=True.
HardTimeout Specifies the number of seconds of inactivity the agent
will wait before reconnecting to the Deployment
Server. The default is 12 hours.
Example: HardTimeout=43200.
APPEND_HOSTNAME_TO_L
OCAL_HOST
This is used should the ADLAgent attempt to append
the new hostname to the hosts file as an ‘alias’ to
localhost.
Example:
APPEND_HOSTNAME_TO_LOCAL_HOST=True.
USER_CHECK_INTERVAL Interval at which adl_users should report changes to
the logged in users. This value is in seconds, with the
default being 6 seconds.
Example: USER_CHECK_INTERVAL=6.
Note: A value of 0 will not send user updates.
KILL_TIME The amount of time in seconds to wait for the agent to
the Deployment Server before killing the adlagent.
This will reboot the system in automation mode.
Currently, this is only supported in automation mode.
The default is 3 minutes.
Example: KILL_TIME=180.
Parameters Details
To Next Page
Loading...
