Deployment Solution 413
Command-Line Switches
Command-line Switches for the Pocket PC Agent
You can manage the Pocket PC Agent through command-line switches. The default path
of the agent executable file is:
C:\Altiris\PPCAgent\PPCAgent.exe.
The following table shows the optional switches and the functions they perform.
Note
If PPCAgent.exe is run and if the agent has not previously been installed, then the agent
will be installed automatically. If the agent was previously installed, it will simply load
the agent.
Command Line Switches for the Pocket PC Agent
Example: to restart the agent, run
C:\Altiris\PPCAgent\PPCAgent.exe -restart
To use more than one command-line parameter, separate the parameters with a space.
Example:
ppcagent -install -silent.
Command-line Install Switches for Linux
The command-line switches used for Linux files are “express path where the bootwiz.exe
is present” -install -os LINUX -x86/x64/ia64” path where the .FRM file is present. The
following table lists the Command-line Install and Silent Install Switches for Linux and
the functions they perform.
Wake On LAN ON/ENABLED
Remote Power Up ON/ENABLED
Power Switch/Wake-up ON/ENABLED
Option Function
-install Installs the agent, or re-installs the agent if already
installed.
-silent
When used with
-install, installs the agent without the
installation dialog screens.
-stop Stops the agent.
-start Starts the agent after it has been stopped.
-restart Stops and restarts the agent.
-remove Stops and uninstalls the agent.
Switch Details
-install -os LINUX -x86
“e:\BDCgpl_6.8.8260.frm”
Installs the Linux agent for x86
computers.
-install -os LINUX -x64
“e:\BDCgpl_6.8.8260.frm”
Installs the Linux agent for x64
computers.
To Next Page
Loading...