Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 - Page 388

Deployment Solution 388
Command-Line Switches
SIDgenCount Specifies the number of times SIDGen has run.
Example: SIDGenCount=0.
Note: This value is set by the AClient and the user
need not set it.
TaskSequence Specifies the task sequence of the task executed by
the AClient.
Example: TaskSequence=0.
ScheduleID Specifies the schedule ID of the last job executed by
the AClient.
Example: ScheduleID=100000008.
Remove Specifies whether to remove AClient from the PC.
Example: Remove=True.
Config Specifies whether to configure the PC.
Example: Config=None, Config=New or
Config=Reply.
Note: Config=Configure.
License
Sysprep2KLicense Specifies the Sysprep License number.
Example:
LicenseNumber Specifies the operating system License Key.
Example: LicenseNumber=5274-649-6478953-
23135.
RegOrganization Specifies the operating system Registered
Organization.
Example: RegOrganization=Altiris.
RegUser Specifies the operating system Registered User.
Example: RegUser=Altiris.
Prompt Specifies whether to prompt the user for the computer
name and to join a Workgroup/Domain during
configuration.
Example: Prompt=True.
Networking
DomainPassword Specifies the domain password.
Example: DomainPassword=FVZSiJELzmpvn[^][@
DomainUsername Specifies the domain user name.
Example: DomainUserName=FVZS@J\iYI ^Vjpsp
DSDomainController Specifies the Domain Controller.
Example: DSDomainController=mycompany.
Parameters Details