Deployment Solution 400
Command-Line Switches
-mip<IPaddress> Function: Specifies the multicast IP address of the Deployment
Server. The default value is 225.1.2.3. If the address is changed on
the Server, use this parameter to change the address in BootWorks so
the client looks for the correct address. The port number must also be
specified if you change this parameter. (See -mp<port>.)
Example: If you changed the Deployment Server’s multicast address
to 225.12.12.13, you would change the address for BootWorks by
typing
bootwork -mip225.12.12.13
-mp<port> Function: Specifies the multicast port address of the Deployment
Server. The default value is 402. If you have changed the port number
of the Server, use this parameter to change the number in BootWorks.
(Any unassigned number that is less than 65536 is valid.) The IP
address must also be specified if you change this parameter. (See -
mip<address>.)
Example: If the Deployment Server’s IP address was changed and you
set a new port number of 1026, type
bootwork -mp1026
-name Function: Prompts the user to enter the name of the client computer.
This name will be registered in the Console Computers list. If no
name is specified, the client computer’s MAC address will be used.
Example: To prompt for a computer name, type
bootwork -name
The client computer will prompt you to enter a name. The name
appears in the Computers list on the Console.
-new Function: Runs Initial Deployment.
Example: To run Initial Deployment on a client computer, type
bootwork -new
-nologin Function: Loads the LAN drivers on the client so BootWorks can check
the Deployment Server for work without completing a user login.
Example: To load the network drivers and check the Deployment
Server, type
bootwork -nologin
-p<port> Function: Specifies the port number of the Deployment Server you
want the client to connect to. The default port number is 402. If you
have changed the port number of the Deployment Server, use this
parameter to change the number in BootWorks. (Any unassigned
number that is less than 65536 is valid.) The IP address must also be
specified if you change this parameter. (See -ip<address>.)
Example: If the Deployment Server’s port number has been changed
to 1026 and clients are not multicasting to find the Server, type
bootwork -p1026
Switch Details
To Next Page
Loading...
