Installing and Configuring the Driver in Windows XP
40 Spectrum24 Wireless LAN Adapter Users Guide
7.2.2 Installing the Driver for Use With the Windows XP Zero
Config Utility
If using the EAP/TLS (802.1x) security protocol with a Symbol Spectrum24
adapter, install the adapter driver without the Symbol Mobile Companion
utility and use the Windows XP Zero Config utility as the adapter
management tool.
If a version of the Symbol Mobile Companion utility resides on the system,
use Windows XP Add/Remove Programs to uninstall it before installing the
driver for use with the Windows XP Zero Config utility.
To install the driver without Mobile Companion in Windows XP:
1. Ensure the previously installed Windows XP driver has been removed.
Verify the PC Card has not been inserted into the PC Card slot.
2. If using a CDROM for the driver installation, insert the CD and copy the
driver files to the system. If downloading the driver from the Symbol Web
site (http://www.symbol.com/services/downloads)
, extract the files to the
computer.
3. Go to the Driver Only_For XP Zero Config folder and launch
XPdriver.exe.
The UpdateXPdriver window displays prompting the user to insert the PC
Card in the system.
4. Insert the PC Card in the system. Click OK.
The UpdateXPdriver window displays again stating the driver files are in
the process of being transferred.
An XPdriver window could display at this point in the installation requesting
the user remove the CD (if it is being used in the installation) from the system.
Remove the CD and click OK.
The Windows XP Found New Hardware Wizard displays.
To Next Page
Loading...