5120A/5115A Operations and Maintenance Manual 29
4.1.3.3 Configuring Network Printers
The network printing feature requires a network printer that supports direct transfer of information
to a port.
1. Configure the test set network connection, following section “4.1.2 Network
Configuration” on page 23.
2. Set the test set to print to the Network destination in the format the printer supports.
3. Enter the IP address and port number of the target printer.
4. Press Apply to save the new configuration.
4.1.4 Viewing Version Information
You can view the model number, software version and hardware CPLD revision numbers when
needed for troubleshooting.
To view the model number and software version:
1. Navigate to the Settings screen (see “4.1 The Settings Screen” on page 21).
2. Press Version Info to access version information.
3. Press Return to go back to previous screens.
4.1.5 Restoring Factory Default Settings
Parameters configured using the Settings submenus persist when the test set is power cycled.
Other settings such as the frequency counter’s user supplied reference frequency and test masks
also persist. All persisted settings can be reset to the values the 5120A or 5115A was shipped with,
using the following steps.
To restore all settings to factory default values:
1. Navigate to the Settings screen (see “4.1 The Settings Screen” on page 21).
2. Press Restore Factory Defaults.
A screen with information about the settings restoration operation is displayed.
3. Press Restore Factory Defaults.
A dialog requesting final confirmation that all settings are to be restored to default
values is shown.
4. Press Ye s .
The test set deletes the current parameter values from persistent storage and reboots.
After it restarts, a dialog confirming that default values have been restored is
displayed.
To Next Page
Loading...
Need help?
General