64 7: Collecting and Viewing Data Remotely
To see the input frequency and power of the signals attached to the test set, enter show inputs. The
test set responds with two sets of frequency and amplitude values for the signals connected to input
and reference port:
Frequency and amplitude of the currently connected signals.
Frequency and amplitude of the signals against which the most recent (or current) data
collection was run.
7.2.8 Setting the User Specified Title
For general information about the user specified title see “3.2.4 User Specified Title” on page 14.
To retrieve the current user specified title, access the command port and run the show title
command.
To set the title that appears at the bottom of all printouts, use the set title command with a quoted
string of up to 34 characters. The title common to many of the screen shots in this manual is set as
follows:
set title “Quartz Oscillator vs Self”
The test set will return a confirmation message showing what the title has been set to. This
provides immediate feedback in case the string you provided is truncated because it exceeds the
maximum length.
7.2.9 Showing the Software Version
Version information, useful for troubleshooting, can be accessed on the command port.
To remotely show the software version:
1. Access the Command port (see page 58).
2. At the command prompt enter:
show version
The commands returns information such as the following:
• Model: 5115A
• DSP CPLD Revs: 03 00 00 00
• ADC CPLD Revs: 01 01 00 00
• ISA CPLD Rev: 0015
• Software: Revision 252
• Options:
• DOCSIS ATP
7.2.10 Viewing Help for Remote Commands
The test set continues to be under development and new commands may have been added to the
command line interface. The help command provides a list of all available commands.
To view a list of all available commands:
1. Access the Command port.
To Next Page
Loading...
Need help?
General