5120A/5115A Operations and Maintenance Manual 65
For more information, see “7.1 Accessing the PNTS Remotely and Exiting the
Remote Session” on page 58.
2. From the Command port Telnet session, enter:
help
A list of all the available commands displays.
To view help for a specific command:
1. Access the Command port.
For more information, see “7.1 Accessing the PNTS Remotely and Exiting the
Remote Session” on page 58.
2. From the Command port Telnet session, enter:
help <command_name>
The usage of the command displays.
This variation of the help command also lists various abbreviations for some
verbose commands. Issuing help measurelinear reveals that ml is a valid
shorthand for the command.
Commands validate their parameters and in most cases provide a list of valid parameters if
arguments are found to be invalid. This too can serve as a source of help using a command.
7.2.11 Setting Data Port Output Rate
The output rate of the data port can be set in samples per second using the set phaserate <rate>
command, where the output rate <rate> can be either 1,10,100, or 1000. The show phaserate
command can be used to determine what the current value of phase rate is.
7.2.12 Other Commands
The following lists some commands that were not documented in detail. Please use the help
network command as the authoritative source for all commands. See “7.2.10 Viewing Help for
Remote Commands” on page 64 for details.
reset
Reset the test set.
restorefactorydefaults
Restores all persistent settings to factory default values and reboots the test set. See “4.1.5
Restoring Factory Default Settings” on page 29 for more information about persistent
settings.
set <option> <args>
date options:
set date YYYYMMDDhhmmss