index
i3
Synrad Firestar ti-Series operator’s manual
description, 3-24—3-25
isolated control circuit, 3-25
sample circuits, 3-24—3-25
Faults
codes, 4-11
keyswitch, 4-11—4-12
laser, 4-11—4-16
OEM, 4-12—4-13
over-temperature, 4-10, 4-11, 4-12—4-13,
4-14
Over Voltage fault, 4-12, 4-13
PWM Drive fault, 4-12, 4-13
remote interlock, 4-10, 4-11, 4-12, 4-14
resetting, 4-11—4-13
RF Drive DC fault, 4-12, 4-13
shutter open, 4-10, 4-11, 4-13, 4-15
Under Voltage fault, 4-12, 4-13
Fault codes 4-11
FCC 7—8
caution to the user, 8
information to the user, 7
Final Test report 1-4, 1-5
Firestar
daily inspections, 4-2—4-3
disabling, 4-2
faults, 4-11—4-16
features, 1-2
maintenance, 4-2—4-5
model numbers, 1-2
mounting, 1-6—1-7
nomenclature, 1-2
optical setup, 3-3—3-4
outline & mounting drawings, 3-32—3-35
packaging instructions, 3-36
packing/unpacking, 1-3
safety features, 9
specifications
ti100, 3-30—3-31
ti60, 3-28—3-29
storage/shipping, 4-3
technical overview, 3-2—3-4
troubleshooting, 4-6—4-17
Firestar base plate 1-6
mounting, 1-6—1-7
Firestar ti-Series laser 1-4, 1-5
Five second delay 9, 2-2, 2-3, 2-5, 2-7, 2-9,
3-10, 3-11, 3-14, 3-15, 3-17, 3-23, 3-26,
3-27, 4-9, 4-11, 4-12, 4-13, 4-15
Flowchart
laser start-up, 4-7
Focusing optics 3-4
Functional block diagram 4-8
Fuse 1-4, 1-5, 2-3
replacement, 4-16
G
Gas purity specifications 3-4
Gated operation 3-8—3-9
General hazards 1—3
General specifications
ti100, 3-30—3-31
ti60, 3-28—3-29
Guidelines
chiller preparation, 1-9
cleaning optics, 4-4
cooling tubing, 1-8
packaging, 1-3
H
Hazard information 1—3
additional laser safety information, 3
disposal, 3
general hazards, 1—3
label locations, 4, 5
other hazards, 3
terminology, 1
I
Incoming inspection 1-3
Indicators and controls 9, 2-2—2-4
Initial start-up 2-5—2-10
with a UC-2000 Controller, 2-5—2-7
without a UC-2000 Controller, 2-8—2-10
Input circuit
equivalent schematic, 3-16
sample diagrams, 3-19—3-20
signal descriptions, 3-14—3-15
signal specifications, 3-16
Input Common 3-10, 3-11, 3-14, 3-15, 3-20,
4-14, 4-15
signal description, 3-15
Input/Output signals 3-12—3-18
Input signals 3-14—3-16
customer-supplied interlock, 3-19
customer-supplied interlock, negative volt-
age, 3-19
Input Common, 3-10, 3-11, 3-14, 3-15,
3-20, 4-14, 4-15