TA I
NSTRUMENTS
TGA 2950 2–29
Adjusting the
Sample Platform
If the sample hang-down wire fails to pick up a
sample pan during an automatic loading proce-
dure, you will need to adjust the position of the
sample platform, using the Sample Platform
Adjust procedure. This procedure is part of the
Instrument Control software program. Refer to
the online help and documentation for further
information on adjusting the sample platform
shown in Figure 2.19.
This procedure assumes that the instrument has
been properly levelled (see page 2-26) and that the
sample hang-down wire is straight.
Figure 2.19
Sample Platform
Assembly
NOTE:
Adjusting the Sample Platform
To Next Page
Loading...
