TA I
NSTRUMENTS
TGA 2950
Installing the 2950
2–20
Unpacking
the Balance
When unpacking the balance, be careful not to
damage the balance arm or hang-down loops.
1. Using the 7/64-inch ball driver supplied in
your TGA accessory kit, loosen and remove
the six screws securing the balance chamber
faceplate to the instrument.
2. Take off the faceplate.
3. Loosen and remove the thumbscrew holding
the balance cover on the sample (left) side
of the balance mechanism (Figure 2.12), and
take off the cover.
Figure 2.12
Interior of Balance
Chamber Before Unpacking
Balance
Cover
Sample
Side
Tare
Side
Tare
Tube
Balance
Cover
Screw
Hang-Down
Loop
t
CAUTION:
To Next Page
Loading...
