TA Instruments TGA 2950 - Page 55

TA I NSTRUMENTS TGA 2950 2–21
4. Using tweezers, remove the foam insert
from around the screw hole (Figure 2.13):
a. Gently compress the foam with the
tweezers, being careful not to touch the
balance.
b. Remove the foam insert from the
balance chamber.
Figure 2.13
Removal of Foam
Insert from Balance
Chamber
5. Replace the sample side cover and screw.
6. Repeat the procedure to remove the foam
insert in the tare (right) side of the balance.
Unpacking the Balance
Foam
Insert