G2.2 T854 Optional Features M8SL2-00-002-812
© Copyright Tait Electronics Limited August 2004. All rights reserved.
2.1.2 Typical Options
2.2 Line Transformer Configuration and Options
There are four Line Transformer options.
%T210 original T800 Line transformer T4030, 300/300:300/300
%T210A ETAL P1200 or similar 600:600 non centre-tapped leaded encapsulated Line
transformer
or ETAL P2602 or similar 300/300:600 centre-tapped leaded encapsulated Line
transformer
%T210B ETAL P2781 or similar 600:600 non centre-tapped SMD encapsulated Line
transformer
or ETAL P2782 or similar 300/300:600 centre-tapped SMD encapsulated Line
transformer
No transformer leaded (%R200 and %R203) or SMD (%R200A and %R203A ) by-pass
resistors fitted, and an attenuator pad if necessary.
The default option is %T210B, SMD P2781 or similar 600:600 non centre-tapped SMD
encapsulated Line transformer.
%T210A and %T210B use a standard footprint which allows the use of other similar
transformers with special characteristics, such as the ETAL P3181 ultra-low distortion
V.9 0 S M D.
PL205 PL210 PL215 PL220
microphone pre-amp. compressed
and pre-emphasised;
line input pre-emphasised
(standard set-up)
3–4
a
B
a. Factory Setting
1–2
a
L
3–4
a
H
3–4
a
E
microphone pre-amp. compressed
and pre-emphasised;
line input unprocessed
3–4
B
3–4
M
7–8
J
1–2
D
line and microphone compressed
and pre-emphasised
5–6
C
5–6
N
7–8
J
3–4
E
microphone pre-amp. compressed;
line and microphone flat response
3–4
B
3–4
M
3–4
H
5–6
F