M8SL2-00-002-812 T800 Ancillary Equipment H1.1
© Copyright Tait Electronics Limited August 2004. All rights reserved.
1 T800 Ancillary Equipment
1.1 Programming Kits
T800-01-0000
The T800-01-0000 kit is used for programming T800 SL2 base station equipment using a
standard IBM
ï›› (or compatible) PC.
The kit comprises the following items:
PGM800Win programming software user's manual
PGM800Win Windows
ï›› based programming software on CD
T800-01-0002 programming cable.
T800-01-0001
The T800-01-0001 kit is the same as the T800-01-0000 kit described above, but with the
addition of the T800-01-0004 module programming interface.
T800-01-0002
The T800-01-0002 programming cable connects the PC directly to the programming
socket on the T800 SL2 rack frame speaker panel or backplane PCB, thus enabling T800
SL2 modules to be read or programmed while in the rack frame. It can also connect to
the programming socket on the T800-01-0004 programming module interface if the
module is to be read or programmed while out of the rack frame.
T800-01-0003
The T800-01-0003 programming kit contains a T800-01-0002 programming cable and a
T800-01-0004 programming module interface.
T800-01-0004
The T800-01-0004 programming module interface is designed to allow a PC to connect
directly to a T800 SL2 module. It comprises a small PCB on which is mounted a D-range
socket, a programming socket, a Micromatch socket and a DC input connector.
The T800-01-0004 plugs directly into D-range 1 or D-range 2 (selected by a switch on the
PCB), or into SK805 in the microcontroller compartment via the supplied ribbon cable
loom, and is then connected to the PC with a T800-01-0002 programming cable.
Refer to the T800 Ancillary Equipment Service Manual for more information.
To Next Page
Loading...
Need help?
General
