H1.1.2 T800 Ancillary Equipment M8SL2-00-002-812
© Copyright Tait Electronics Limited August 2004. All rights reserved.
1.2 General Ancillaries
T800-09-0001 RF Coaxial Relay
The T800-09-0001 is an RF coaxial relay assembly fitted with three female N-type con-
nectors, and comes complete with a mounting bracket and two coaxial cables termi-
nated in male N-type connectors. It can be used, for example, in base station
applications where the receiver and transmitter share the same antenna, in which case it
can be driven by the T800 SL2 transmitter relay driver (refer to Section 2.4 in Part G for
more information).
T800-01-0010 Calibration Test Unit
The T800-01-0010 provides all inputs and outputs necessary to carry out the full tuning
and adjustment procedure for T800 Series I and II receivers, exciters and transmitters. It
provides a convenient method of connecting test equipment, including a PC and power
supply, to a T800 Series I or II module (via D-range 1) without the need to construct cus-
tom wiring looms.
The T800-01-0010 also has a built-in speaker, a switch for selecting Series I or II modules,
and uses standard BNC and “banana plug” sockets.
T800-03 Auxiliary D-Range
The T800-03 is an additional D-range kit comprising one D-range plug assembly and
two locating pins, nuts and washers. Although originally a T800 Series I ancillary, it can
be used in T800 SL2 products for special applications requiring custom internal wiring.
T800-03-0000 Auxiliary D-Range
The T800-03-0000 is an additional D-range kit (normally fitted as D-range 2) comprising
one D-range plug assembly complete with connecting loom and mounting screws. The
ribbon cable loom connects the D-range PCB to the Micromatch socket (SK805) in the
microcontroller compartment. Typical uses of the T800-03-0000 are in paging applica-
tions and where external channel control is required. Refer to
Figure 1.4 in Part G for the
T800-03-0000 pin connections.
To Next Page
Loading...
Need help?
General
