28
Installing an accessory
Warning Use only IS-approved accessories with IS radios. For an
up-to-date list of FM-approved accessories, go to the Tait website
or contact your nearest Tait office. For detailed information about
IS radios and how to identify them, see "Intrinsically Safe radios"
on page 16.
Accessories plug into the radio’s accessory connector. The
accessory connector is protected by a cover, which needs to be
removed before an accessory can be installed.
Notice The accessory cover protects the accessory connector
from electrostatic discharge. Keep the cover in place unless the
connector is in use.
To remove the accessory cover and install an accessory:
1 Use a coin or other blunt object to
loosen the screw that secures the
accessory cover to the radio.
2 Remove the accessory cover and
store it in a safe place.
3 Plug the accessory into the
accessory connector.
4 Tighten the screw.
To Next Page
Loading...
