98
MAINTENANCE
Service Data
Fuel and Lubricant Chart
Use different fuels, lubricants and greases according to the temperature, referring to the
chart below.
¡ Change the lubricant earlier than as shown in the table if it is extremely dirty or its
performance has deteriorated severely.
¡ Whenever possible, use the same brand of lubricant as before. If changing with a different
brand, replace the entire quantity – do not mix different brands.
* For water, use tap water (soft). Do not use well or river water.
** When the ambient temperature drops below 0°C, add coolant (antifreeze). Follow the
coolant manufacturer’s instructions to determine the mixture ratio.
Part
Type
Type by temperature
-22 -4 14 32 50 68 86
104
°F
-30 -20 -10 0 10 20 30 40°C
Replacement
interval
Capacity
RR
RR
R(US. qt.)
Engine
oil pan
Diesel
engine oil
API - CD
After first 50
hrs.
Every 250 hrs.
Upper limit:
TB014: 3.0 (3.2)
TB016: 2.8 (3.0)
Lower limit:
TB014: 1.7 (1.8)
TB016: 1.5 (1.6)
System:
TB014: 33 (34.9)
TB016: 33.5 (35.4)
Tank:
23 (24.3)
Hydraulic
tank
Antiwear
hydraulic oil
(Option:
Biodegradable
oil)
Every 2000 hrs.
Use a clean, Quality fuel for good performance and optimum engine life.
¡ To prevent fuel flow problems in cold weather, use diesel fuel with a pour point of at
least -12°C (10°F) below the lowest expected ambient temperature.
¡ Minimum cetane number is 45. Low temperature or high altitude operation may
require the use of fuel with a higher cetane number.
Fuel tank
Diesel fuel
Tank:
21 (22.2)
Engine
cooling
system
Coolant (water*
+ coolant**)
Every 1000 hrs.
3.4 (3.6)
SAE 5W-20
SAE 10W-30
SAE 15W-40
Travel
reduction
gear
Gear oil
API-GL-4
SAE 90
After first 250 hrs.
Every 1000 hrs.
0.33
(0.35)each
Slew motor
pinion
Slew
bearing
Working
equipment
Levers
Lithium
based
grease
EP-2
NLGI No. 2
Every 50 hrs.
Every 50 hrs.
Daily or every
10 hrs.
When
required
As
required
ISO VG32
ISO VG46
ISO VG68
50% coolant mixture
30% coolant mixture
To Next Page
Loading...
Need help?
General
