Takeuchi TB014 User Manual

109
MAINTENANCE
Daily Inspection (Every 10 Hours)
Inspecting the Water Separator
WARNING
Stop the engine and allow the machine
to cool down before performing
inspection and maintenance.
< TB014 >
< TB016 >
1. Open the engine hood.
2. Inspect the water separator (1).
If the red indicator ring (6) is sunk to the
bottom of the case (4), no water is mixed
in.
If the red indicator ring (6) is floating, there
is water up to the bottom of the ring. Drain
the water and clean.
Refer to page 119 “Cleaning the Water
Separator”.
Checking the Fuel Level
WARNING
¡¡
¡¡
¡ Do not smoke or permit open flames
while fueling or near fueling
operations.
¡¡
¡¡
¡ Stop the engine in a well-ventilated
place when adding fuel.
¡¡
¡¡
¡ Clean up spilled fuel immediately.
¡¡
¡¡
¡ Do not fill the fuel tank to capacity.
Allow room for expansion.
¡¡
¡¡
¡ Tighten the fuel tank cap securely.
1. Check the fuel level using the sight gauge
(1).
2. If the level is low, add fuel from the fuel
port (2) while watching the sight gauge (1).
Refer to page 42 “Fuel Filler Cap”.
C4G009
1
2
6
3
5
4
2
Closed
1

Takeuchi TB014 Specifications

General

Engine	Yanmar 3TNV70
Overall Width	980 mm
Transport Width	980 mm
Bucket Capacity	0.04 m3
Max Digging Depth	2260 mm