Takeuchi TB014 User Manual

122
MAINTENANCE
Every 250 Hours
8. Light up the inside of the element with a
bulb, inspect it, and replace it if there are
small holes or thin spots.
9. Remove the cloth or tape applied in step 5.
10. Install the element (6).
11. Install the dust cup (5) with the “TOP”
mark at the top, then fasten it with the
clamp (4).
12. Press the button (3) on the dust indicator
(1) to push the red piston (2) back in.
C4G025
E4G034
C4G006
3
1
2
Cleaning the Radiator Fins and
Oil Cooler Fins
WARNING
Wear required appropriate equipment
such as safety glasses and filter mask
when using compressed air, as metal
fragments or other objects can fly and
cause serious personal injury.
IMPORTANT: Be careful not to damage
the radiator fins and oil cooler fins when
cleaning them.
¡¡
¡¡
¡ When using compressed air or
pressurized water, make sure the
pressure is no higher than 200 kPa (28
psi) and hold the nozzle sufficiently
away from the fins.
IMPORTANT: When using water, cover
the electrical system to prevent water
from getting in.
IMPORTANT: When operating the
machine in very dusty places, inspection
and maintenance should be performed
every day.
1. Blow compressed air on the radiator fins
and oil cooler fins to remove mud and dirt
stuck on them.

Takeuchi TB014 Specifications

General

Engine	Yanmar 3TNV70
Overall Width	980 mm
Transport Width	980 mm
Bucket Capacity	0.04 m3
Max Digging Depth	2260 mm