MAINTENANCE
General
Do
not clean parts with fuel
Do
not use fuel to clean parts. Use a non-
combustible cleaning agent.
Keep dirt out
When mounting and removing parts,
do
so
in
a place where there
is
no dust, clean the
working
area
and the part, and keep dirt
out.
Clean mounting surfaces
When mounting and removing parts, be sure
that the surfaces
of
contact
of
the parts
are
clean. If the sealing grooves of the surface
of
contact
are
damaged, consult a Takeuchi
dealer.
Seals and split pins
• Replace removed seals and split pins with
new ones.
• When mounting, be careful not to damage
or twist the
seal.
Sealing tape
Sealing tape
(
\
Leave 1 or 2 threads free
E4G001
• When wrapping sealing tape around
plugs, etc., remove any old sealing tape
from the threads and clean the threads.
• Wrap the sealing tape tight, leaving 1 or 2
threads at the tip free.
107
Disposing of wastes
• Collect waste fluids from the machine
in
containers. Disposing
of
wastes
irresponsibly damages the environment.
• Dispose of oil, fuel, cooling water, coolant,
filters, batteries and other harmful
substances
as
prescribed by
law.
Check
after maintenance
• Gradually increase the engine speed from
a low idle to maximum speed and check
that there
is
no
oil
or water leaking from
serviced parts.
• Operate
all
the control levers and check
that the machine
is
operating properly.
Cautions on handling of battery cables
• Disconnect the battery cables(+,-) before
working on the electrical system or doing
any welding.
Remove the negative (-) battery cable
first.
When reconnecting the battery, connect
the negative (-) battery cable last.
•
Do
not disconnect the battery cables
while the engine
is
running. Doing so
could damage the electronic circuitry
of
the alternator and other parts.
To Next Page
Loading...
