MAINTENANCE
Important Parts
For safe use, the machine must be serviced periodically.
To
increase safety, periodically replace
the parts listed
in
the following Table of Important Parts.
Serious injury or a fire could result if they deteriorate or are damaged.
Table of Important Parts
Unit
Important
parts
to
be
replaced periodically
Replacement
Interval
Fuel system
Fuel hoses
PackinQ
in
fuel filler
cap
Engine connection EnQine oil filter hoses
Heater &
AC
systems
Heater hoses
Air conditioner hoses
Machine
Hydraulic hoses (Pump - delivery)
body
Hydraulic hoses (Pump - suction)
Every 2 years
Hydraulic
Hydraulic hoses (Travel motor)
system
Hydraulic hoses (Lift arm cylinder lines)
Working
Hydraulic hoses (Bucket cylinder lines)
equipment
Hydraulic hoses (Quick hitch cylinder lines)
Hydraulic hoses (Pilot valve)
Hvdraulic hoses (Auxiliarv lines)
Seat belt
Everv 3 vears
Above important parts
are
vulnerable
to
aging and wear or deterioration and it is difficult
to
determine the degree
to
which they have deteriorated during periodic service.
To
maintain
their proper function at all times, therefore, replace them with new ones after using them for a
specific period of time, even if no abnormality
is
found with the parts. If you find abnormalities
in
these parts before their scheduled replacement time
is
reached, repair or replace them
immediately. If a hose clamp is deformed or cracked, replace it immediately.
When replacing the important parts, please contact a Takeuchi dealer.
Also check the hydraulic hoses other than the above important parts. If any abnormality is
found
in
them, retighten them or replace them immediately.
When replacing the hydraulic hoses, replace the 0-rings and seals at the same time.
Check the fuel and hydraulic hoses according
to
the periodic schedule described below.
Refer to "Maintenance."
Type of inspection
Daily inspection
Monthly inspection
Annual inspection
Inspection item
Leakage from joints, hydraulic or fuel hoses.
Leakage from joints, hydraulic or fuel hoses.
Damaged hydraulic or fuel hoses (cracks, wear and tear).
Leakage from joints, hydraulic or fuel hoses.
Deteriorated, twisted, damaged hydraulic or fuel hoses (cracks, wear
and tear) or hoses
in
contact with other parts
of
the machine.
113
To Next Page
Loading...
