MAINTENANCE
Every 50 Hours
• If the fluid
level
can not be checked by
fluid
level
lines.
Remove the caps
(2)
and look into the
fluid supply holes to check the fluid level.
If the fluid
is
below the sleeve
(3)
, be sure
to add distilled water up to the bottom
edge
of
the sleeve
(3)
.
Proper amount .........
(A)
The fluid reaches up to the bottom
edge
of
the sleeve
(3)
, so the surface
tension causes the fluid to swell and
the plate appears distorted.
Level too low ...........
(B)
The fluid does not reach up to the
bottom edge
of
the sleeve
(3),
so the
plate appears laminar, not distorted.
4.
Also check the terminals for looseness
and dirt.
Replenishing
When adding distilled
water,
do so before
starting operations
in
order to prevent
freezing.
1.
Remove the bolts
(a)
and open the radiator
(b).
133
2. Remove the indicator(1) and caps
(2)
, and
add distilled water up to the upper level.
3.
Tighten the indicator
(1
), which then turns
blue.
4.
Clean the cap's exhaust hole, then tighten
the caps
(2)
securely.
To Next Page
Loading...
