SAFETY
Maintenance
Precautions
Have a Takeuchi service agent
repair welding
If welding must be performed, make sure that
it
is
done by a qualified person
in
a properly
equipped workplace.
To
prevent any part
from breaking down or being damaged
due to overcurrent or sparks, observe the
following.
• Disconnect the wiring from the battery
before doing electric welding.
•
Do
not continuously apply 200 V or
more.
• The earth ground must be connected
within one meter from the welding
section.
Do
not connect the earth ground
near to
an
electronically controlled device/
instrument or connectors.
• Make sure that there
are
no seals or
bearings between the welding section
and
the earth ground.
•
Do
not connect the earth ground around
the pins for the working equipment or
hydraulic cylinders.
• When welding
is
to be done
on
the
machine body, disconnect the connectors
for the electronically controlled devices
before working.
Vibrations operators are subject
to
According to the results of the tests carried
out to determine the vibrations transmitted
to the operator by the machine, the upper
limbs
are
subjected to vibrations lower than
2.5 m
(8
.2
ft
.) I s
2
,
while the seated part of the
body
is
subjected to vibrations lower than
0.5 m
(1.64
ft
.) I s
2
.
34
Checks after maintenance
• Gradually raise the engine speed from low
idle to maximum speed and check that
no oil or water
is
leaking from serviced
parts.
• Move the controls and check that the
machine
is
operating properly.
Disposing of wastes
E3A640
• Pour waste fluids from the machine into
containers. Disposing of fluids improperly
destroys the environment.
• Follow the prescribed regulations when
disposing of oil, fuel, engine coolant,
refrigerant, solvents, filters, batteries
and
other harmful substances.
Handling
of
poisonous chemicals
Poisonous chemicals will cause serious
injury if directly contacted.
Poisonous chemistry used
in
this machine
includes grease, battery solution, coolant,
paint and adhesive agent.
Handle the poisonous chemicals properly
with care.
To Next Page
Loading...
Need help?
General
