CONTROLS
Instrument Panel
Indicators
6.
Glow Lamp
3
Meters
8. Hour meter
This lamp turns off when
engine preheating
1s
completed.
B This displays the total engine
running time
in
hours.
~H
'"'
The rightmost digit indicates
o L3B019 h f h (
tent s o ours 6 minutes).
Set the inspection and maintenance intervals
according to the time displayed on the hour-
meter.
9.
Coolant Temperature Gauge
This gauge indicates the
temperature
of
the engine
coolant.
The needle should be within
the green range during machine operation.
The
red
range indicates overheating.
10. Fuel Gauge
F
~
This gauge indicates the
ft!
O amount
of
fuel
in
the tank.
\
r,,
Be
sure to top off the tank
E L
39021
before running out of fuel.
55
Engine Fault Warning Lamp
< TL220 I TL230 I TL240 >
<TL230 I TL240>
Applicable machine models
TL230: 223000923 or later
TL240: 224000810 or later
IMPORTANT: If the lamp flashes, check
the flashing pattern, stop the engine and
then contact a Takeuchi dealer for help.
Do not
run
the engine while the lamp
is
flashing. Otherwise, the specified engine
performance cannot be obtained or more
serious problem can occur.
When the ignition switch
is
turned to the
ON
position, the lamp lights up and stays on for
2 seconds and then goes out.
If a problem arises
in
the engine or controls,
the lamp starts flashing, with the flashing
pattern corresponding to the type
of
problem.
To Next Page
Loading...
Need help?
General
