Talkpod A36plus MAX - Selecting the Frequency Mode

The transceiver has frequency selecting modes, as described below
：
In standby mode, long-press the [Menu] key to toggle between Frequency Mode and Channel Mode.
F
requency Mode
1. In standby mode, long-press the [Menu] key to switch to FR mode.
2. Use the [Up/Down] keys to change the frequency or directly input the desired full frequency using
the numeric keys.
Channel Mode
1. In standby mode, long-press the [Menu] key to switch to CH mode.
2. In this mode, use the [Up/Down] keys to change the channel number or directly input the desired
channel using the numeric keys. At least one memory channel must be programmed; otherwise, you
cannot enter this mode.
3
. In Channel Mode, long-press the [Back] key to toggle between Channel Name Mode, Channel
Frequency Mode, and Channel Number Mode.
Note:
1. The principle of setting the squelch level is based on the environment and requirements of use.
2
. When a greater communication distance is required, which weakens the received signals, a higher
sensitivity is needed, and thus a lower squelch level should be set; for example, set to Level 1.
3
. For shorter communication distances with stronger received signals, sensitivity can be decreased
by setting a higher squelch level, which reduces noise; for example, set to Level 9.
4
. If intermittent transmission occurs, indicating weak signal reception, or if the communication
distance changes during a conversation making it hard to hear, then lower the squelch level to
increase sensitivity; for example, adjust from Level 8 to Level 2.
Selecting The Frequency Mode
9
Long Press
145800