Tally Dascom 1140 - Page 40

Tally Dascom 1140
25
Paper Setup
Valid Settings
Function
Skip
No, Yes
Skips printing on perforation area.
Only valid to fanfold.
Yes: Blank lines between 2 pages.
No: No blank lines between 2 pages.
Tear
Auto, Manual,
View, Auto @ FF
Auto: No incoming print data in 1~2 seconds after
printing completed, the printer advances the form
to the tear-off position. When the printer receives
new print data, the form is ejected to the top-of-
form.
Manual: After the completion of a print job, press a
panel key to advance the paper to the tear-off
position.
View: No incoming print data in 1~2 seconds after
printing completed causes the printer to advance
the paper by 2 lines. Printing resumes 2 lines
below the torn edge.
Auto @FF: a form feed command is necessary to
auto feed the form to tear position.
Buzzer
No, Yes
No: Buzzer does not sound if out of paper.
Yes: Buzzer sounds if out of paper.
BlackMark
No, Yes
No: Disables black mark sensor.
Yes: Enables black mark sensor.
When “Yes” and online, pressing the Load/Eject
key advances the paper to the tear-off position.
BlackMark commands: (also see section 5.6)
 1D 0C:
Feeds paper to the print position designated by
the black mark. Advance the paper to the tear-off
position after printing.
 1C 28 4C 03 00 42 m:
m = 0: feeds paper to the print position
designated by the black mark.
m = 1: feeds paper to the black mark tear-off
position.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es