THE
DOS
COMMANDS
COMMAND:
MODE
~ ~
FORMAT:
mode
,r,f
EXPLANATION: With certain video monitors, the first few
characters of a line may not, at first, be visible on the screen.
If
your video monitor does not have a horizontal adjustment
control that enables you to move these characters onto the screen
(move them to the right), you can use the MODE command.
For other uses
of
the MODE command (e.g., setting up the
computer to use a serial printer), refer to the Disk Operating
System manual.
PROCEDURE:
1.
Obtain the
DOS
prompt for the drive that contains your
DOS
programs.
2.
In response to the DOS prompt,
Type:
NOTE
THE FORMAT
IS
IMPORTANT. TYPE THE
COMMAND,
A
SPACE, A COMMA, AN
“R”,
A
COMMA, AND A “T”.
2
-
54
To Next Page
Loading...
