4.
Insert the DOS diskette (Section
1.4),
but do not close the
door of the diskette drive.
5.
Turn on the system unit power switch.
If
you have just
turned off your computer, you must wait at least
15
seconds
before turning
it
on again. In approximately
10
seconds,
you should see the test status message displayed in the top
left comer of your monitor screen.
(
xxxK Byte
RAM
Tested
I
NOTE
THE DIGITS IN THE TEST STATUS MESSAGE
ARE CONSTANTLY CHANGING.
6.
As soon as you obtain the test status message, close the
door
of
the diskette drive.
NOTE
IF YOUR MONITOR SCREEN REMAINS BLANK,
OR
IF
YOU RECEIVE AN ERROR MESSAGE
RATHER THAN
A
TEST STATUS MESSAGE,
REMOVE THE DISKETTE AND TURN OFF THE
COMPONENTS
OF
YOUR SYSTEM. GO BACK
TO STEP
1
AND TRY THE PROCEDURE ONCE
AGAIN. IF YOU ARE STILL UNSUCCESSFUL,
REFER TO APPENDIX C.
1
-
18
To Next Page
Loading...
