Tandy 1500HD - Using the Power Program in Deskmate

7500 HD LaDtoD CornDuter
USING THE POWER PROGRAM
IN DESKMATE
You can change several of the computer’s power-
parameters by running the Power program from
DeskMate. The Power program temporarily over-
rides the Setup program’s power-management pa-
rameters.
The Power program lets you:
Enable and disable Automatic Floppy Disk
Stand by
Enable or disable the speaker
Enable or disable the Low Power tone
Set the Display Timeout
Set the Hard Disk Timeout
Notes:
The changes you make using the Power pro-
gram are immediately active.
The changes you make using the Power pro-
gram are lost when you turn
off your computer.
When you turn on your computer again, it re-
turns to the Setup parameters.
34