53
Model C606 Operating Procedures
Step 3
Check scraper blades for any nicks or signs of wear.
If any nicks are present, replace the blades.
Note: Shake side scraper blades should be
replaced every 6 months.
Step 4
If the blades are in good condition, place each
scraper blade over the holding pins on the beater
assembly. (See Figure 105.)
Figure 105
Note: The holes in the scraper blade must fit over
the pins to prevent damage.
Step 5
Holding the blades on the beater assembly, insert
the beater assembly in the freezing cylinder. Engage
the shaft end firmly into the drive shaft socket. (See
Figure 106.)
Figure 106
Note: When properly seated, the beater will not
protrude beyond the front of the freezing cylinder.
Step 6
Assemble the draw valve spinner assembly. Inspect
draw valve o-rings for cuts or nicks. (Replace if cut
or nicked.) If draw valve o-rings are in good
condition, slide the 2 o-rings into the grooves of the
draw valve and lubricate. (See Figure 107.)
Figure 107
Step 7
Lubricate the outer diameter of the spinner shaft
seal. Fill the cups on each end of the seal with
lubricant.
Figure 108
To Next Page
Loading...
