54
Model C606Operating Procedures
070228
Step 8
Insert the spinner shaft seal into the bottom of the
draw valve as far as it will go. The spinner shaft seal
should fit into the seal groove located inside the
draw valve cavity.
Important: Inspect to see that the spinner shaft
seal is correctly installed in the groove. A worn,
missing, or improperly installed spinner shaft seal
will cause product leakage out the top of the draw
valve. (See Figure 109.)
Figure 109
Step 9
Lubricate the smaller end of the driven spinner.
(See Figure 110.)
Figure 110
Step 10
Squeezing the split end together, insert the driven
spinner through the metal opening of the draw valve
until it snaps into place. (See Figure 111.)
Figure 111
Step 11
Insert and align the draw valve spinner assembly
into the shake door as shown. (See Figure 112.)
Figure 112
To Next Page
Loading...
