Taylor C606 - Page 67

61
Model C606 Operating Procedures
Step 4
Insert the piston into the retaining pin hole end of the
pump cylinder. (See Figure 138.)
Figure 138
Step 5
Assemble the valve cap. Slide the red o-ring into the
groove of the valve cap. DO NOT lubricate the
o-ring. (See Figure 139.)
Figure 139
Step 6
Slide the pump valve gasket into the holes on the
cap. DO NOT lubricate the gasket.
(See Figure 140.)
Figure 140
Step 7
Insert the valve cap into the hole in the mix inlet
adapter. (See Figure 141.)
Figure 141