Taylor C606 - Page 68

62
Model C606Operating Procedures
Step 8
Insert the mix inlet assembly into the pump cylinder.
(See Figure 142.)
Figure 142
Note: The adapter must be positioned into the
notch located at the end of the pump cylinder.
Step 9
Secure the pump parts in position by sliding the
retaining pin through the cross holes located at one
end of the pump cylinder. (See Figure 143.)
Figure 143
Note: The head of the retaining pin should be
located at the top of the pump when installed.
Step 10
Assemble the feed tube assembly. Slide the check
ring into the groove of the feed tube. (See
Figure 144.)
Figure 144
Step 11
Install one red o-ring on each end of the mix feed
tube, and thoroughly lubricate. (See Figure 145.)
Figure 145